postheadericon Quadbox 30 Series Receiver

QFX-QUAD30-RX

PESA's Quadbox RX modules are fiber to coax conversion modules that provide increased port density and total routing system cost savings. The Quadbox modules support up to four ASI/SDI, HD-SDI or 3G-SDI signals utilizing a 2.97Gb/s optical transport per fiber port. Using two SFP duplex small form factor pluggable modules, these units offer broadcast quality coax to fiber transmission paths in a single throw-down box or can be setup in groups of four in a 1RU frame setup. Quadbox is compliant with SMPTE 259M, 292M, 372M, and 424M ensuring highly flexible and reliable media conversion for any application.

Each QFX Quadbox module allows high definition video with or without embedded audio and data, as well as DVI-ASI. And because the Quadbox Series is based on a fiber transport, you can be assured that each signal is immune to video pathological signals over the entire length of the fiber interconnect.  Either singlemode or multimode cabling is supported. When using singlemode, the Quadbox can support distances up to 10Km and up to 600m with Multimode using industry compliant LC connectors.

The Quadbox fiber system is the lowest total cost solution for converting copper-based signals to fiber-based transmission paths and works exceptionally well with all PESA HD router systems. Each Quadbox comes with a built-in Ethernet port and USB port for easy setup and diagnostics. Up to four QFX modules can be loaded in a 1RU frame with support for redundant power. Setup is simple with the supplied GUI interface.

 

 

Features

  • 4 fiber to copper transmission ports per module
  • 1310 nm optical laser transport signals
  • Supports both multimode and singlemode cabling
  • Supports both 62.5µm and 50µm multimode
  • 4 independent channels allows for HD-SDI, 3G-SDI, or Dual-Link HD-SDI
  • Supports SMPTE 259M-C, 292M, 372M, and 424M
  • Video data rates from 143Mbps to 3.0Gbps
  • Optional model available to support 143Mbps to 1.5Gbps
  • Software setting for reclocking or by-pass mode
  • Extend copper cabling up to 50m from module
  • Low power consumption, less than 4.5W per module
  • Small form factor module allows up to four units in a 1RU space
  • Up to 16 input or output channels in 1RU
  • Ethernet port for network capabilities
  • USB 2.0 for local setup and diagnostics
  • Optional 1RU frame with redundant power
  • Optional under-the-table mounting bracket for single modules
  • 12VDC, 90-240VAC 60/50Hz power brick for stand-alone modules
  • 90-240 VAC, 60/50Hz redundant power supply for the 1RU frame

Images



 




Specifications

Digital Specifications

Inputs / Outputs for Coax
Connector Type 75 Ohm
Return Loss >15dB from 5Mhz to 1.5Ghz; >10dB, 1.5Ghz to 3GHz
Input cable equalization SMPTE 259M - 300m; SMPTE 292M - 100m; SMPTE 424M - 80m
Based on Belden 1694A or equal
Output Signal Level 800mV, p-p, +/-10%
Output Signal Polarity Non-inverted
Inputs/Outputs for Fiber
Connector Type Dual Optical SFP (small form factor pluggable) Compliance with ITU-T G.957
Connector Style LC
Input Data Rates 143 Mbps to 1.5Gbps - ASI/SD/HD; 143 Mbps to 3.0Gbps - SD/HD/3G
Optical Input wavelength Singlemode ( 1310 optimal)
Input Power -20dBm (min); -1dBm (max)
Output Data Rates 143 Mbps to 3.0Gbps; Auto reclocking to SMPTE 259M, 292M, 424M.
Bypass mode - 143Mb to 3Gbps
Output Power -9dBm (min); -3dBm (max)
Optical Loss Budget Approx. 9dB (Assumes two optical connections over a 10Km singlemode fiber)
Jitter < 0.2UI, p-p, SMPTE 259M, 292M; <0.3UI, p-p, SMPTE 424M compliant with RP-184
Fiber Transmission Specifications IEC 61754-20-1
Typical Operating Distances 9/125u ( 10Km / 6.25 miles); 50/125u (400m / 1200 feet); 62.5/125u (200m / 600feet)

NOTE: Operating distances are approximate only. Cable loss and other interconnects can affect the total light loss between a TX and RX path. These are only estimates and may not reflect the actual lengths achievable.

 

 

SEE PESA AT THE FOLLOWING EVENTS


NAB 2014
Las Vegas Convention Center
April 7-10, 2014
Las Vegas, NV
BOOTH SL4619

Guest pass code- LV7768

Click here to get your free pass

 


 

INFOCOMM 2014
Las Vegas Convention Center
June 18-20, 2014
Las Vegas, NV
BOOTH C6014


 

 


Networking